Milwaukee 4210-1
Once it is in position, it can do some amazing drilling; getting it into an awkward position can be a challenge. It will turn as slow as 5 rpm with torque like no other for use with large hole saws. The feedback speed control is the best available. I've drilled 5 inch holes using a bimetal hole saw through half inch steel with the rig positioned vertically and the saw was still sharp after a dozen holes. I did use some coolant, but a hole saw hand held would be toast after a single hole. I once fixed stripped head bolt holes with helicoils in the block of an antique engine by aligning the drill with the ... This combination unit features the 4202 fixed position, variable speed base and the 4262-1 3/4in All
Milwaukee 4210-1 you need is a bit and you are ready to drill
Milwaukee 4210-1 into any ferrous material 1/2 in Volts: 120, Amps: 12.5, Speed (RPM):
Milwaukee 4210-1 350, Drilling Capacity (in.): 3/4, Chuck Size (in.):
Milwaukee 4210-1 3/4 Feedback speed control Solid state electronic switching ... »»
Read more... » Check Discount Price. 
No comments:
Post a Comment